Support Forums Forums Knife Sharpening Procedure experiment Tradesman Edge

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #193
    Up
    0
    Down
    Tradesperson
    Participant

    Soft platen , belt horizontal , set bar height about 1,5 inch length of blade support from point of contact with the bar to the edge of the knife 6 inches
    This is about 15 degrees apex angle
    using trizact trailing edge 320 grit  a few strokes till bur is uniformly evident moderate pressure about 1500 SFMOnce a burr is evident swap to leather belt
    2000 SFM leather trailing edge more pressure (as the platen is soft it allows more edge contact under greater pressure without changing angle setting)  this produces a microscopically small convexity and takes out the burr

    Share
Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.
Share